You’d better use a big volume hard disk as "Write-back File Path". "Write-back File Path" is used to store the LAN booted clients’ write-back data. Set "Write-back File Path" and "Image Save Path" as you want. Normally, it’s the same as "DHCP Server IP". You need to stop other DHCP services on the LAN. Press "Scan DHCP" to check if there are other DHCP services on the LAN. You need to select the correct local IP address as "DHCP Server IP". Launch the LAN boot software - CCBoot, menu "Options"->"Options Wizard" and configure step by step as bellow: Launch CCBoot and you will get the main interface as bellow: Note: Please shut down the other DHCP services on the LAN especially the DHCP service in the router. Since CCBoot v2.1, you also need to open port 66. You need to open these ports in the firewall of the LAN boot server. Launch ccbootsetup.exe on the LAN boot server and keep press the next button to the end.ĬCBoot will use the following ports – 67 (DHCP), 69 (TFTP), 3260 (iSCSI), 1000 (Image Upload), 8001 (Service Control).
Install LAN Boot Server with CCBoot - An All-in-one LAN Boot Softwareĭownload LAN boot software - CCBoot server installation package from.It can also bring you enhanced Disaster Recovery solutions.
If you want to install or upgrade various softwares for all computers in the network, you just need to do it once. 2nd stage boot).Īs an administrator responsible for a network of about dozens of computers or more, LAN boot solution will drastically reduce your daily workload. CCBoot support install windows xp over lan and install windows xp over network.įor LAN boot solution, the boot process is as bellow:ģ, PXE stack built-in the NIC (Network Information Center),Ĥ, Download NBP (Network Boot Program) from server to client's RAM by TFTP,ĥ, NBP's responsibility to perform the next step (a.k.a. It is therefore ideally suited for both diskless and thin clients. LAN boot program allows to remote boot a computer over LAN without a hard disk. The client is a computer you want to boot up over LAN, while the server is a computer which provides necessary data such as NTLDR, NBP (Network Boot Program), system image and so on for client booting over LAN. It requires two computers: LAN boot server and client. LAN boot is a technology based on IP (Internet Protocol), UDP (User Datagram Protocol), DHCP (Dynamic Host Configuration Protocol) and TFTP (Trivial File Transfer Protocol).